Full Product Manual

WEEKLY MAINTENANCE

1. Check oil level in Pump and fill if necessary. To

check oil level remove vented fill cap. Technician should

visibly be able to see the oil level inside the hole. Insert

a dip-stick or piece of plastic into the tank until it hits the

bottom. Remove the stick and measure the amount. The

oil level should be 3 3/8” to 3 ½” inches deep.

(See Fig 7.4)

2. Lubricate all rollers with general purpose oil or

WD-40.

3. Check all Hose connections, bolts and pins to ensure

proper mounting.

4. Lubricate Safety lock pivot points with general

purpose oil or WD-40.

5. Check and tighten Cylinder Bolt. (See Fig. 7.5)

MONTHLY MAINTENANCE

1. Lubricate the Cylinder Pin and Main Hinge Pin with

all purpose grease using a needle point lube coupler.

(See Fig. 7.6 & 7.7)

2. Check Safety Locks to ensure they are in good

operating condition.

3. Make a visual inspection of ALL MOVING PARTS

and check for excessive signs of wear.

4. Replace ALL FAULTY PARTS before lift is put back

into operation.

t NEVER EXCEED THE RATED CAPACITY of lift.

t DO NOT USE LIFT if any component is found to be

defective or worn.

t NEVER OPERATE LIFT with any person or

equipment below.

t ALWAYS STAND CLEAR of lift when lowering or

raising.

t ALWAYS INSURE SAFETY LOCKS ARE

ENGAGED before entering work area.

t NEVER LEAVE LIFT IN ELEVATED CONDITION

unless all four safety locks are engaged.

Fig. 7.5

Fig. 7.4

Fig. 7.6

Fig. 7.7

Vented Fill Cap