Product Manual

ASSEMBLY AND OPERATING INSTRUCTIONS

NOTE: Please refer to the Assembly Diagram for the following installation instructions.

1. Insert funnel #7 into upper tube #3 and secure it tightly by two screws #8

2. Connect the upper tube #3 into the lower tube #2 and secure it tightly by bolt #4, washer

#5 and nut #6

3. Put the lower tube #2 into the tank #1 and secure it by tightening the adjusting clamp # 11

4. Screw the cap oat gauge #10 into the drain tube on the tank #1.

This completes the assembly.

5. To operate the oil drain, slightly unscrew the adjustable clamp and allow the two tubes and

the funnel to slide downward to the lowest position.

6. Move the 8 gallon oil drain under the raised vehicle, making sure the funnel is positioned

directly below the oil drain plug of the engine.

7. Raise the upper tube and funnel until the funnel sits approximately 4” directly below the

oil drain plug of the engine. Then, tighten the adjustable clamp to hold the upper tube, lower

tube and the funnel in place.

8. Remove the oil drain plug of the engine, and allow the old oil to completely drain from the

engine into the funnel of the 8 gallon oil drain.

9. Once the old engine oil is completely drained, replace the oil drain plug of the engine.

10. When the cap oat gauge starts to rise and you see the red rod appearing your tank is

near full and should be emptied.

11. When emptying the old oil from the tank of the oil drain, make sure to follow guidelines

for engine oil disposal. If necessary, contact your local solid/liquid waste authority for infor-

mation on recycling and/or disposal.

# PART # DESCRIPTION EXPLODED

VIEW/QTY.

1 1325106 8 GALLON OIL DRAIN TANK 1

2 1325104 LOWER TUBE 1

3 1325103 UPPER TUBE 1

4 1325108 1/4-20 x 2.5” HEX HEAD BOLT 1

5 1325109 1/4” FLAT WASHER 1

6 1325110 1/4-20 HEX NUT 1

7 1325102 FUNNEL 1

8 1325101 FUNNEL SCREW 2

9 1325112 SCREEN 1

10 1325111 CAP FLOAT GAUGE 1

11 1325105 ADJUSTING CLAMP 1

12 1325107 SWIVEL CASTER 4