Installation Guide
Table Of Contents
- D4-9 Manual
- Table of Contents
- Introduction
- Shipping Information
- Safety
- Additional Product
- Components
- Specifications
- Installation Checklist
- Installation
- Safety Rules
- Using Tools
- Clearances
- Usable Area
- Selecting a Location
- Planning for Electrical Work
- Unloading and Unpacking
- Selecting your Power Post Location
- Creating Chalk Line Guides
- Moving the Posts into Position
- Installing the Crosstubes
- Raising the Crosstubes
- Installing the Runways
- About Safety Locks
- Installing the Safety Lock Release Mechanism
- About the Pivot Pieces
- Installing the Top Caps
- Routing the Lifting Cables
- Installing the Safety Covers
- Installing the Power Unit
- Installing the Flex Tube
- Hydraulic Fluid Contamination
- Installing the Hydraulic Hose
- Working with Compression Fittings and Tubing
- Installing the Return Line
- Contacting the Electrician
- Connecting to a Power Source
- Adding Hydraulic Fluid
- Installing a Power Disconnect Switch
- Installing a Thermal Disconnect Switch
- About Embedment
- Anchoring the Posts
- Final Leveling
- Installing Accessories
- Lubricating the Lift
- Performing an Operational Test
- Final Checklist Before Operation
- Operation
- Maintenance
- Troubleshooting
- Wiring Diagrams
- Labels
- Parts Drawings
- Automotive Lift Institute (ALI) Store
D4-9 / D4-9X Four-Post Lifts 49 P/N 5900251 — Rev. A— October 2020
Drive-up Ramps
Your Lift comes with two Drive-up Ramps, which are installed onto the Rear of the Lift so that Vehicles
can drive onto and off of the Runways.
To install the Ramps:
1. Install the four Ramp Mount pieces; one on each end of both Runways. Each takes two Bolts.
Important: Be careful
not
to disturb the Safety Release mechanism when you install the four
Ramp Mount pieces.
2. To install a yellow, steel Ramp, put it into place next to the Ramp Mount Piece, align the holes on
the Ramp with the holes on the Ramp Mount piece, then slide the rod through the holes.
3. To install a silver, aluminum Ramp, slip the end into place in the gap between the end of the
Runway and the Ramp Mount Piece.