Installation Guide
Table Of Contents
- D4-9 Manual
- Table of Contents
- Introduction
- Shipping Information
- Safety
- Additional Product
- Components
- Specifications
- Installation Checklist
- Installation
- Safety Rules
- Using Tools
- Clearances
- Usable Area
- Selecting a Location
- Planning for Electrical Work
- Unloading and Unpacking
- Selecting your Power Post Location
- Creating Chalk Line Guides
- Moving the Posts into Position
- Installing the Crosstubes
- Raising the Crosstubes
- Installing the Runways
- About Safety Locks
- Installing the Safety Lock Release Mechanism
- About the Pivot Pieces
- Installing the Top Caps
- Routing the Lifting Cables
- Installing the Safety Covers
- Installing the Power Unit
- Installing the Flex Tube
- Hydraulic Fluid Contamination
- Installing the Hydraulic Hose
- Working with Compression Fittings and Tubing
- Installing the Return Line
- Contacting the Electrician
- Connecting to a Power Source
- Adding Hydraulic Fluid
- Installing a Power Disconnect Switch
- Installing a Thermal Disconnect Switch
- About Embedment
- Anchoring the Posts
- Final Leveling
- Installing Accessories
- Lubricating the Lift
- Performing an Operational Test
- Final Checklist Before Operation
- Operation
- Maintenance
- Troubleshooting
- Wiring Diagrams
- Labels
- Parts Drawings
- Automotive Lift Institute (ALI) Store
D4-9 / D4-9X Four-Post Lifts 34 P/N 5900251 — Rev. A— October 2020
4.
Switching to the Attachment Plate and the Power Unit
: Put the Vibration Dampener in
place, and then secure the Power Unit using four M8 x 1.25 x 25 Bolts, M8 Washers, and M8
Nuts.
Tip The Power Unit is heavy. We recommend having one person hold the Power Unit while
another person secures it in place.
5. Find the Safety Placard and Zip Tie from the Parts Box, then use the Zip Tie to attach the Safety
Placard to one of the unused holes on the Power Unit Plate.
6. Slide the Flex Tube Bracket over the two Bolts that are closest to the side of the Powerside
Runway.
Not necessarily to scale. Not all components shown.
7. Securely tighten the Bolts and Nuts.
Do not connect the Power Unit to a power source at this point.