Full Product Manual

7.3 Check and make sure the platform is level, adjust cables if necessary as described

in the Installation Instruction section of this manual.

7.4 Check oil level.

7.5 Make sure there is no air in the system, bleed as described in the Installation

Instruction section of this manual.

Lift lowers approximately 1" and stops.

8.1 Check and make sure all safety locks are released.

At full height the latch will not release and the lift will not lower.

9.1 If the equalizer cables are out of adjustment, the platform is out of sync. When the lift

is at full rise, one of the safety latches may not have cleared the ladder and will not

allow the lift to lower.

9.2 To lower the lift:

9.3 Raise the lift to full height.

9.4 Make sure all 4 latches are engaged.

9.5 Use a hydraulic jack and a fitted pipe to raise the corner that is sticking and release

the safety latch.

9.6 Pull the latch release handle to disengage the latches.

9.7 Remove the jack and pipe.

9.8 Lower the lift and remove the vehicle.

9.9 Re adjust the cables as described in the Installation Instruction section of this manual.

LIFT LOCKOUT/TAGOUT PROCEDURE

Purpose:

This procedure establishes the minimum requirements for the lockout of energy that could cause

injury to personnel by the operation of lifts in need of repair or being serviced. All employees shall

comply with this procedure.

Responsibility:

The responsibility for assuring that this procedure is followed is binding upon all employees and

service personnel from outside service companies (i.e., authorized installers, contactors, etc.). All

employees shall be instructed in the safety significance of the lockout p ocedure by the facility

owner/manager. Each new or transferred employee along with visiting outside service personnel shall

be instructed by the owner/manager (or assigned designee) in the purpose and use of the lockout

procedure.

Preparation:

Employees authorized to perform lockout shall ensure that the appropriate energy isolating device

(i.e., circuit breaker, fuse, disconnect, etc.) is identified for the lift being locked out. Other such

Page 28

For technical questions, please call 877.432.6627