Full Product Manual

IMPORTANT INSTRUCTIONS
PLEASE READ!
LIFT OPERATION:
To Raise Lift:
1. Position vehicle tires in the center of each runway.
2. Set parking brake and use wheel chocks to hold vehicle in position.
3. Before raising the vehicle make sure you replace the drive up ramps with the tire stops, make
sure all personnel are clear of the lift and surrounding area. Pay careful attention to overhead
clearances.
4. Raise the lift to the desired height by pressing the push button of the power unit.
5. Lower lift on nearest safety ladder to support load.
6. Do not permit the cables to go slack.
Page 19
For technical questions, please call 877.432.6627
Safety
Lock
Block
Safety
SAFETY IN LOCKED POSITION
VISUALLY CONFIRM THAT ALL PRIMARY SAFETY LOCKS ARE ENGAGED BEFORE ENTERING
WORK AREA.
Hydraulic components used on this lift are intended to raise and lower lift only and are not meant
to be load holding devices. Remain clear of elevated lift unless visual confirmation is made that all
primary safety locks are fully engaged and the lift is lowered onto the safety locks. Refer to manual
for proper safety lock procedures.
DANGER