Full Product Manual

ManualsBrandsDannmar ManualsTools & HardwareCommander 7000 lb. 4-Post Lift with Accessory Kit

STEP 2

(Column & Cross Bar Installation)

IMPORTANT! DO NOT begin installation with lift close to wall. It is necessary to leave adequate

clearance for installing safety linkage rods. Allow 120" on opposite side of power unit location

and 60” on the Safety Handle Side (power unit side) for clearance.

Make a chalk line on the floor following the floor plan above to ensure unit is square.

Stand the columns in place making sure to position the power unit mounting bracket at the

correct location ( see “X” above ) and making sure the extended lip on all the posts are facing the

inside of the lift ( see fig. 4 ) Note: You can also lay the columns down and slide the cross tubes

in, you may need to disengage the spring on the primary safety.

Remove safety covers for installation and replace

when final assembly is done. Raise one of the

cross bars ( both cross bars ar

e the same ) and

slide it into the two front columns making sure to

position the primary lock devise OUTWARD and

the cable pulleys INWARD. Manually clear the lock

devise on each side of the cross bar and slide the

cross bar down until it rests on the safety lock

position closest to the floor. (Be sure to re-engage

safety spring if it was removed.)

5. Repeat this process for the rear cross bar. You will

then have the columns and cross bars in position

and spaced properly for the runways.

6. With the columns and cross bars in place, secure

the column TOP CAPS using the M12 X 130MM Hex

Bolt, Nylon Lock Nut & Washer. (See Fig. 4)

Page 9

For technical questions, please call 877.432.6627

“X” Indicates your two options

for Power Unit Location (Passen-

ger Rear recommended).

WARNING

Be very careful not to disturb the columns and

cross bars at this time as they may tip over causing

personal injury or harm.

Fig. 4

Notice the extended

lip on the post, this

should always face

the inside of the lift.

INSIDE

OUTSIDE

Please note the differences on

each side of the posts. The lock

blocks extend further out on one

side, this side should always

face the inside of the lift.