Full Product Manual

Page 13
For technical questions, please call 877.432.6627
sure to point the fitting towa ds the power unit. On the pipe thread side of the fitting use teflon
tape or pipe sealer. DO NOT USE TEFLON TAPE on JIC flared end.
5.
Install the pneumatic push-to-connect 90-degree fitting at the cylinder port closest to the power
unit making sure to point the fitting towards the power unit. On the pipe thread side of the fitting
use Teflon tape or pipe sealer.
6.
Connect hydraulic hoses as shown below making sure to first pass through the retaining rings
located on the inside of the runway. MAKE SURE HOSES ARE KEPT CLEAR OF CABLES.
NOTE: When tightening connections with flared (JIC) fittings, always follow the tightening
instructions. Failure to follow these instructions may result in cracked fittings and / or leaks.
1.
Screw the fittings in HAND TIGHT.
2.
The nut portion of the fitting is the only part that should turn during tightening. The fitting
MUST NOT turn.
3.
Then use the proper size wrench to tighten the nut portion of the fitting. Do not over-tighten.
4.
Back the nut portion of the fitting off one full turn.
5.
Again, tighten the nut portion hand tight without moving the fitting.
Insert Spacer
as shown.
Fig. 10.2
Insert Spacer
as shown.
Fig. 10.1
Fig. 9
Return
Air
Vent
Pressure
Port
Filler Cap