Full Product Manual

20
7. Push the RAISE button or rotate the control switch on
the power unit.
Important Note:
Allow 2-seconds between motor starts.
Failure to comply may cause motor burnout.
8. Stop before making contact with vehicle. Check con-
tact points. If required, slightly move arms or vehicle to
allow restraint gear and pawl to mesh.
9. Raise vehicle until tires clear the oor.
10. Stop and check adapters for secure contact at vehicle
manufacturer’s recommended lift points.
11. Continue to raise to desired height only if vehicle is
secure on lift.
12. DO NOT go near or under a raised vehicle if all four
adapters are not in secure contact with vehicle at vehicle
manufacturer’s recommended lift points.
13. Repeat entire loading and raising procedures if
required.
14. Lower lift onto safety locks.
• DO NOT enter work area or go under vehicle if safety
locks are not engaged.
• CLEAR AREA if vehicle is in danger of falling.
• DO NOT position yourself between a wall and the lift.
If the vehicle falls in that direction, you may be severely
injured.
• Before attempting to lift pickup trucks or other truck
frame vehicles, be sure that:
t Vehicle frame is strong enough to support its
weight and has not been weakened by
modication or corrosion.
t Vehicle individual axle weight does not exceed
one-half lift capacity.
t Adapters are in secure contact with frame at
vehicle manufacturers recommended lift points.
t Vehicle is stable on lift and neither front nor “tail”
heavy.
WHILE USING LIFT
• Avoid excessive rocking of vehicle while on lift.
• Always use safety stands as needed or when
removing or installing heavy components.
DANGER!
VISUALLY CONFIRM THAT ALL PRIMARY
SAFETY LOCKS ARE ENGAGED BEFORE
ENTERING WORK AREA.
Suspension components us on this lift are
intended to raise and lower lift only and are
not meant to be load holding devices.
Remain clear of elevated lift unless visual
confirmation is made that all primary
safety locks are fully engaged and the lift is
LOWERED onto the safety locks, Refer to
installation /operation manual for proper safety
lock procedures and /or further instruction.