Full Product Manual

6. Raise the lift off the safety locks by pressing the

push button on the power unit. Make sure you raise the

lift by at least two inches to allow adequate clearance for

the safety lock to clear. ( See Fig. 8.3 - 8.5)

8. Lower lift by depressing lowering valve on power

unit.

9. Run the lift up and down a few times to ensure that

the locks are engaging uniformly and that the safety

release mechanisms are functioning. Re-adjust if

necessary

STEP 9

(Bleeding)

1. Lift must be fully lowered before changing or adding

fluid.

2. Raise and lower lift six times. The cylinder is self

bleeding. After bleeding system, fluid level in power unit

reservoir may be down. Add more fluid if necessary to raise

lift to full height. It is only necessary to add fluid to raise lift

to full height.

3. To pressure test, run lift to full rise and run motor for

approximately 3-seconds after lift stops. This will place

pressure on the hydraulic system. Stop and check all fittings

and hose connections. Tighten or reseal if required.

POST-INSTALLATION CHECK-OFF

tLift Assembly, Level And Stable

tArm Assemblies Properly Attached

tElectric Power Supply Confirmed

tSafety Locks Functioning Properly

tCheck For Hydraulic Leaks

tOil Level

tLubrication of Critical Components

tCheck For Overhead Obstructions

tRunways Level

tAll Screws, Bolts, and Pins Secured

tSurrounding Area Clean

tOperation, Maintenance and Safety Manuals on Site

Fig 8.4

Fig 8.3

Safety Unlocked

Fig 8.5