Full Product Manual

STEP 5

(Lift Arm Installation)

1. Set the Adjustable Arm on the Ramp ensuring that the

Bolt on the arm is inserted through the arm holder channel

on the side of the ramp. (See Fig. 5.1)

3. Tighten the M-20-10 nut until the arm cannot pivot, then

back the nut off until the arm is just loose enough to pivot

freely. (See Fig.5.2)

STEP 6

(Installing / Changing Lift Pads)

1. Remove the Socket Head Screw from the end of the lift

arm.

2. Slide the desired height Lift Pad riser onto the lift arm.

Replace and tighten the Socket head Screw. Drop in the Lift

Pad if applicable. (See Fig.3.)

Repeat the above procedure for the other three arms.

Use the 3" Lift Pad Extension as necessary to reach

proper lifting points on the vehicle.

Fig 5.1

Fig 6.1

Fig 5.2

WARNING!

ALWAYS set the adjustable arms and pads under the

proper lifting points as indicated in the Lifting Guide or

owners manual of the vehicle.

Lift Pad

Assembly

M12 x 1.75 x

20mm Screw