Full Product Manual

STEP 3

(Power Unit Set Up)

1. Set the Power Unit on the Stand/Tow Handle and

mount using the four M8 x 1.25 x 20mm Bolts, Nuts and

Washers. (See Fig 3.1)

2. Remove plug from power unit and install the 90°

Fitting w/ O-ring into the power port on the Power Unit.

Take care to make sure the O-ring seats properly.

Connect the 144" Hydraulic Hose to the 90° Fitting.

Fill the reservoir with 6 quarts/1.5 gals of AW-32 or

Dexron III or VI automatice transmission fluid.

STEP 4

(Connecting Hydraulic Fittings / Hoses)

1. Remove the plastic plug from the left port of the left

hand Cylinder.

2. Install the Straight Hydraulic Fitting in the left port of

the left hand Cylinder. Use Teflon tape on the Cylinder

side on the Fitting only.

Attach the 144" Hydraulic Hose to the Straight

Fitting in the port of the left hand side Cylinder.

Check the 21.25" Hose connections and 90° Fittings

on the right side of the left side Cylinder Fitting.

Then check the other end of the 21.25" Hose and 90°

Fitting on the left fitting side of the right hand Cylinder.

5. The right side hydraulic port of the right Cylinder

should be plugged with a metal plug. Check plug and

tighten if necessary. (See Fig 4.1)

Fig 3.1

Fig 4.1.