Full Product Manual

FOR TECHNICAL QUESTIONS, CALL [phone]
23
Make sure vehicle is neither front nor rear heavy. Center of balance should be midway between adapters
as shown below.
6. Push the RAISE button or rotate the control switch on the power unit.
Important Note:
Allow (2) seconds between motor starts. Failure to comply may cause motor burnout.
7. Stop before making contact with vehicle. Check arm restraint pins for engagement. If required, slightly
move arm to allow restraint gear and pawl to mesh. DO NOT hammer arm restraint pin down as this
will damage the restraint gear teeth.
8. Raise vehicle until tires clear the floor.
9. Stop and check adapters for secure contact at vehicle manufacturer’s recommended lift points.
WARNING