Full Product Manual

 Columns are properly shimmed and stable

 Anchor bolts are tightened

 Pivot / sheave pins are properly attached

 Electric power supply conﬁrmed

 Cables are adjusted properly

 Safety locks are functioning properly

 Check for hydraulic leaks

 Oil level

 Lubcation of critical components

 Check for overhead obstructions

 Lift arms are level

 All screws, bolts, and pins are secured

 Surrounng area is clean

 Operation, maintenance and safety manuals on

site.

VISIT US ON THE WEB AT WWW.DANNMAR.COM20

POST INSTALLATION CHECK OFF

LUBRICATION POINTS

1. After installation and start up has been completed, lubricate the lift components described below

on both columns with white lithium grease.

(See ﬁgure 14)

A. All 4 sides of Column where slide blocks

make contact.

B. All 4 Arm Pivot Pins.

C. All 6 Cable Pulleys.

STEP 17

OPERATION INSTRUCTIONS

LIFT OPERATION SAFETY

• DAILY inspect your lift. Never operate if it

malfunctions or if it has broken or damaged

parts. Use only qualiﬁed lift service personnel

and genuine Dannmar parts to make repairs.

• THOROUGHLY train all employees in use and

care of lift, using manufacturer’s instructions

and “Lifting It Right” and “Safety Tips” sup-

plied with the lift.

• NEVER allow unauthorized or untrained per-

sons to position vehicle or operate lift.

• PROHIBIT unauthorized persons from being in

shop area while lift is in use.

• DO NOT permit anyone on lift or inside vehicle when it is either being raised or lowered.

• ALWAYS keep area around lift free of tools, debris, grease and oil.

• NEVER overload lift. Capacity of lift is shown on nameplate afﬁxed to the lift.

Fig: 14