Full Product Manual

VISIT US ON THE WEB AT WWW.DANNMAR.COM16
STEP 7
(Wiring the Power Unit)
1. The standard power unit for your lift is 220 volt, 60HZ, single phase. ALL WIRING MUST BE PER-
FORMED BY A CERTIFIED ELECTRICIAN ONLY.
2. SEE WIRING INSTRUCTIONS AFFIXED TO MOTOR FOR PROPER WIRING INSTRUCTIONS.
IMPORTANT INSTALLATION NOTES
• DO NOT PERFORM ANY MAINTENANCE OR INSTALLATION OF ANY COMPONENTS WITH OUT
FIRST ENSURING THAT ELECTRICAL POWER HAS BEEN DISCONNECTED AT THE SOURCE OR
PANEL AND CANNOT BE RE ENERGIZED UNTIL ALL MAINTENANCE AND / OR INSTALLATION
PROCEDURES ARE COMPLETED.
• NEVER operate the motor on line voltage less than 208V. Motor damage may occur which is not cov-
ered under warranty.
• DO NOT run power unit with no oil. Damage to pump can occur.
• The power unit must be kept dry. Damage to power unit caused by water or other liquids such as de-
tergents, acid etc., are not covered under warranty.
• Improper electrical hookup can damage the motor and will not be covered under warranty.
• Motor can not run on 50HZ without a physical change in the motor.
• Use a separate breaker for each power unit.
• Protect each circuit with a time delay fuse or circuit breaker.
• For 208 -230 volt, single phase, use a 20 amp fuse.
• For 208-230 volt, three phase, use a 30 amp fuse.
• For 460 volt, three phase, use a 30 amp fuse.
• DO NOT attempt to raise vehicle until a thorough operation check has been completed.
DANGER
WARNING