Full Product Manual

STEP 4

(Installing Jack on Rails)

1. Lower the Rolling Bridge Jack all the way down.

2. Using a shop crane, forklift or other lifting device raise

the Rolling Bridge Jack and place it in between the

Runways. (See Fig. 4.1)

3. Lower the Rolling Bridge Jack to just above the Utility

Rails on the inside of the Runways.

4. Adjust the Rolling Bridge Jack Ends to the correct

width. (See Fig. 4.2)

NOTE: 18-25K models do not have adjustable arms.

5. When the desired width is reached, lower the

Rolling Bridge Jack into the Utility Rails. Double check

that all 4 Rollers are seated properly in or on the Utility

Rails. (See Fig. 4.3 & 4.4)

6. Ensure that the Utility Rail Channel is clean of debris,

tools etc.

7. Locate the Safety Brackets. Install brackets on the

Rolling Bridge Jack Ends using the provided M6 hard-

ware. (See Fig 4.5)

NOTE: Only 4.5, 6K, & 7K models include Safety

Brackets.

WARNING!

When removing or moving the Rolling Bridge Jack

from shipping pallet pay close attention as the Jack

may move and can cause injury.

Prior to removing the strapping or bolts make sure

the Jack is held securely by a fork lift or some other

heavy lifting device.

Fig. 4.1

Fig. 4.2

Fig. 4.3

Fig. 4.4

WARNING!

Read and understand all instructions before using

this jack. Adjust rolling jack telescoping ends until

rollers rest securely on runway tracks as shown.

NEVER use rolling jack unless safety bracket is

installed. REMAIN CLEAR of elevated rolling jack

unless visual confirmation is made that jack rollers

are secure on runway tracks. BE CAREFUL WHEN

ADJUSTING ROLLING JACK OR LIFT RUNWAYS to

prevent rolling jack from becoming separated from

runway tracks. Failure to read, understand and fol-

low these instructions may cause death or serious

injury.