Compatibility Chart

Can I use air tools?
No, it is forbidden to use any air tools. If air tools are used, the gear boxes will be damaged; the
warranty does not cover these types of damages. It is also forbidden to use any impact tools.
Can I use a cordless drill?
It depends on the power of the battery drill. If it is strong enough and if it is not an impact drill, then it
can be used. If an impact drill is used, the warranty will not cover any damages!
When is it necessary to use the beam pads?
Make sure the lift rests on a solid part of a vehicle to prevent any damage of plastic or fragile parts. It is
recommended to use beam pads when lifting vehicles with an extended plastic side skirt etc.
Can I drive over the MaxTilt with the vehicle?
No. It must be placed under the vehicle from the side. WARNING: It is forbidden to drive over the
MaxTilt, because such behaviour may cause damage to the vehicle and to the MaxTilt as well. The
warranty does not cover these types of damages.
What are the dimensions of the space necessary to use the MaxTilt?
5.5’ (1.65 m) from the side of the vehicle. For standard passenger vehicles, a garage with a height of 8’
(2.5 m) is sufficient, but it always depends on the length and type of the vehicle. WARNING: Always
check the height of the ceiling before tilting the lifted car! Before you raise the vehicle, check your entire
surroundings to make sure there is plenty of working space so as not to hit any parts of the vehicle or
ceiling etc. The manufacturer and seller are not responsible for any injuries or damages that are result of
incorrect usage while lifting and/or tilting.
What to do when there is a power outage – how can I lower the vehicle?
In such case, a mechanical handle must be used (It can be bought as an accessory – it is not included in
the package). Alternatively, use a ½ ratchet wrench (gola).
Does the MaxTilt need any maintenance (e.g. lubrication of the trapezoidal screw)?
MaxTilt does not need any maintenance. It contains a lifelong amount of lubrication without any need of
a refill. Any tampering with the MaxTilt hardware is not recommended and may affect the warranty.
Does the MaxTilt require any official revisions? (e.g. like a column lifting device)
No, the MaxTilt doesn’t require any official annual revision.
How should I grab the vehicle if I want to tilt it?
It is recommended to grab the vehicle by the part touching the floor (front or back of the vehicle);
always grab the vehicle by a solid part (i.e. fender, trunk etc). Always make sure that grabbing part is
solid enough. The manufacturer and seller are not responsible for any injuries or damages that are result
of incorrect grabbing a tilting.
In what way and in what environment can I store MaxTilt when it is not in use?
The MaxTilt can be kept leaning against the wall on its gear box housings or hanging on the wall using a
special holder (it can be purchased as an accessory). There are no special conditions required for storage
of the MaxTilt, except that the temperature of the room in which the MaxTilt is stored should be
between 0 °C (35 °F) and +40 °C (104 °F). WARNING: The product should be assembled, used and stored