Compatibility Chart

Platform width
1300 mm - 1650 mm
What is the maximum time a vehicle can remain lifted by the MaxTilt?
The MaxTilt is capable of keeping a vehicle at a chosen height indefinitely. There is no time limit and the
position is fixed. Always use the safety locking pin and jack stand before venturing under any lifted
vehicle, no matter how long or short a time period.
How can I recognize the point of gravity of each vehicle, so I can tilt the vehicle easily?
There are 3 basic layout of passenger vehicles:
1) The most common one is the layout with the engine at the front of the vehicle with front wheel drive.
Position the MaxTilt under the vehicle so that the gear boxes are about 4” (10 cm) from front wheels.
2) Layout with the engine at the front of the vehicle with rear-wheel drive (Mercedes, BMW). The gear
boxes should be about 12” (30 cm) from the front wheels.
3) Layout with the engine at the back of the vehicle with rear-wheel drive (Porsche). Position the MaxTilt
so that the gear boxes are about 4” (10 cm) from the back wheels, and the lift must be in a reverse
position.
Do I always have to lift a vehicle to the MaxTilt’s maximum height?
No – the MaxTilt can be stopped at almost any chosen height. You can stop it at any height between 0-
23.5” (0-60 cm). Always remember to put the locking pin in place.
Can I lift electric and hybrid cars with my MaxTilt?
Yes. As always, make sure the lifting platforms or riser bars are not pressing against any underbody
components, pipes, cables, etc. before lifting the vehicle. If the battery parts of an electric vehicle are
extended into the chassis part of the vehicle, be careful to prevent damage to these parts.
What height will my vehicle be at the back or front when fully lifted on the MaxTilt?
This varies from one vehicle to the next depending on where the MaxTilt has been placed under the
vehicle and how long the front and rear vehicle overhangs are. Always check that the ceilings in the
building are high enough to accommodate your vehicle comfortably when raised.
What can I do if my drill adapter breaks?
The dimensions of the drill adapter were developed by our engineering department in a way to prevent
damage to gear boxes or any injury to the person operating the MaxTilt. Therefore, the adapter can only
break if the user doesn’t follow the instructions when using the drill. This happens when you exceed the
minimum or maximum height (the lifting limit is 23.5” (60 cm) and the minimum vehicle height is 4.25”
(11 cm). Every package of MaxTilt contains 4 adapters.
Can I use the MaxTilt outside on rough or unstable ground?
Yes, the MaxTilt can be used both inside and outside. Use the available uneven rails to help support the
vehicle’s weight and to protect the MaxTilt load wheels from any potential damage.
My vehicle weighs exactly 3000 kg (6614 lbs), should I be afraid to use the MaxTilt when its maximum
lifting weight is 3000 kg (6614 lbs)?
The MaxTilt is approved for the lifting capacity of 3000 kg (6614 lbs), but the testing was performed with
a heavier load. Thus you can use it to safely lift vehicles weighing 3000 kg (6614 lbs).