Product Manual

2
STEP 12
OPERATION
To raise lift:
1. Load the vehicle onto the lift using vehicle lifting guide to determine proper lifting points.
2. Never use lift pad assemblies without rubber slip over pads in place.
3. Set the parking brake or use a wheel chock to hold the vehicle in position.
4. Before raising vehicle, be sure all personnel are clear of the lift and surrounding area. Pay careful
attention to overhead clearances.
5. Raise the lift to the desired height by pressing the push button on the
power unit.
6. After the vehicle is raised to the desired height, pass the safety lock
bars through each column then lower lift onto the lock bars. Always
nsure safety lock bars are installed before entering work area.
(See figure24)
To lower lift:
1. Before lowering vehicle, be sure all personnel are clear of the lift and
surrounding area. Pay careful attention to overhead clearances. Insure
all tools and equipment have been cleared from under the lift.
2. Raise the lift off of the safety lock bars by pressing the push button on
the power unit. Make sure you raise the lift by at least one inch to allow
adequate clearance for the safety bars to be removed. Remove lock
bars.
3. Push the lowering handle on the power unit until the lift has descended completely.
WARNING
When lowering the lift pay careful attention that all personnel and objects are kept clear.
Always keep a visual line of site on the lift at all times. Always make sure that both lock
bars are removed.
Fig. 24
Fi. 24 ipla
are lit pa.
e oel oe
tanar it ron
lit pa or reater
railit. Call or
ore inoration.
*
•
•
WarningDN
•
•
•
NEER
•
NEER
FOR TECHNICAL QUESTIONS, CALL