Product Manual

•
Always follow the bleeding instructions outlined in the manual prior to using your lift.
•
Read operating and safety manuals before using lift.
• Always lift vehicle according to manufacturer’s recommended lifting points.
• Position vehicle between columns. Adjust swing arms so that vehicle is positioned with the center of
gravity midway between pads.
• Position lift contact pads at manufacturers recommended lifting points.
• Use truck adapters as needed. Never exceed 6" of pad / adapter height.
• Raise lift by pressing raise button on power unit until contact pads make contact with the underside of
vehicle.
• Recheck to make sure vehicle is secure.
• Raise vehicle to desired working height then press power unit
• Lowering handle until lift carriages rest onto nearest safety lock position.
• Maintain visual contact with vehicle and surrounding area at all times while raising lift.
• Stop immediately if load shifts or becomes unlevel.
• Always ensure safety lock bar(s) are installed before any attempt is made to work on or near vehicle.
• Always ensure contact pads are making full contact with vehicle before attempting to work on or near
vehicle.
    
OPERATION SAFETY     
•
It is important that you know the load limit. Be careful that you do not overload the lift . If you are un-
sure what the load limit is, check the data plate found on one of the lift columns or contact the manu-
facturer. The center of gravity should be followed closely to what the manufacturer recommends.
•
Always make sure you have proper overhead clearance. Additionally, th attachments,
(vehicle signs, campers, antennas, etc.) are not in the way.
Be sure that prior to the vehicle being raised, the doors, trunk, and hood are closed securely.
•
Prior to being raised, make sure there is no one standing closer than six feet from the lift.
After positioning the vehicle on the lift runways, set the emergency brake, make sure the ignition is off,
the doors are closed, overhead obstructions are cleared
• Put pads or adapters in the right position under the contact points that have been recommended.
•
The lift should be raised just until the vehicle’s wheels are about one foot off the ground. If contact
with the vehicle is uneven or it appears that the vehicle is not sitting secure, carefully lower the lift and
readjust.
• Always consider potential problems that might cause a vehicle to slip, i.e., heavy cargo, undercoating,
etc.
• Pay attention when walking under a vehicle that is up on the hydraulic lift.
   LOWER LIFT
• Raise lift by pressing raise button on power unit. Elevate lift at least one inch to allow adequate clear-
ance to remove lock bar(s).
• Remove both safety lock bar(s).
• Be sure tool trays, stands or personnel are removed from under vehicle.
• Lower vehicle by pressing power unit lowering handle until lift has descended completely.
• Maintain visual contact with vehicle and surrounding area at all times while lowering lift.
• Stop immediately if load shifts or becomes unlevel.
• Before removing vehicle from lift area, position lift arms to provide unobstructed exit.
• NEER drive over lift arms.
WWW..COM
20