Product Manual

FOR TECHNICAL QUESTIONS, CALL 
13
STEP 4
( MOUNTING THE HYDRAULIC POWER UNIT )
Assemble cart as shown in the figured below:
. After installing the cart wheels, attach the
power unit and rubber power unit damp-
ener pad to the power unit cart using the
 8x25mm hex bolts and nylon locknuts.
(See figure 6)
. Attach the hydraulic flow divider to the
power unit cart using the  8x20mmhex
bolts and nylon lock nuts supplied.
(Seefigure 7)
. Remove the plastic plug  the
“IN” on the
flow divider. Install the long 90
degree N fitting. Use
teflon tape onpipe thread
only. When tightingthe fitting,
tighten by hand firstandthen using
a wrench turn 3 fullturns past
hand tight.(See figure8)
6. Remove the plastic plug from the
power unit. Install the long 90de-
gree No-ring 
.
7. Attach the short power unit hose
as shown. Do not use teflon tape
on the JIC fittings. (See figure 9)
NE

