Product Manual
12
STEP 3
( INSTALLING THE HYDRAULIC CYLINDERS )
1. After installing the column wheels, turn the columns over and lay them down with the open side up.
Slide the upwards until they are almost to the top of the columns. Remove the cylinders.
(See figure 1)
2. Install the cylinder fittings as shown
using teflon tape on the pipe threads.
(See figure 2)
3. the cylinders through the
.
(See figure 3)
4.
Position the cylinder fittings through
the access hole located on the backside of the columns. (See figure 4)
5. Lower the until it rests firmly on the baseplate. Stand the columns up.
6. Install the column tie bars using the M10x45mm hex bolts, nuts and washers. (See figure 5)
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Shown with break-
out to show top
and bottom plate
WWW..COM
Cliner
it ea