Solar Force Install and User Manual

Installation & Service Manual
Innovative Solar Solutions, Inc
Main (866) 856-
9819
If you are using this pump in a pressurizing system, you need a pressure switch, available
any pump or electric supply, or from your dealer. You may use the type used for AC
1/2 HP models
require the large “heavy duty” size. The pressure switch
pressures your pump will turn on (cut
liking, or leave it set at the factory settings. The lower the
115VAC Models:
Wire exactly as above. White is “neutral” and black is “hot”.
Explanation:
The National Electrical Code
“grounded conductor”, which is the negative. So, we are
sets of contacts as shown (wired in series) will extinguish the arc (spark) that forms when the
contacts break. This greatly increases switch reliability.
Installation & Service Manual
Innovative Solar Solutions, Inc
\ 1730 Camino Carlos Rey
, Unit 101/ Santa Fe, NM 87505
9819
\ Fax [phone] /
www.innovativesolar.com
5
Pressure Switch
If you are using this pump in a pressurizing system, you need a pressure switch, available
any pump or electric supply, or from your dealer. You may use the type used for AC
require the large “heavy duty” size. The pressure switch
determines at what
pressures your pump will turn on (cut
-in) and off (cut-out). You may
adjust your switch to your
liking, or leave it set at the factory settings. The lower the
pressure, the less en
required.
Wire exactly as above. White is “neutral” and black is “hot”.
The National Electrical Code
®
specifies that switches not disconnect the
“grounded conductor”, which is the negative. So, we are
switching only the positive. Using both
sets of contacts as shown (wired in series) will extinguish the arc (spark) that forms when the
contacts break. This greatly increases switch reliability.
2010
, Unit 101/ Santa Fe, NM 87505
www.innovativesolar.com
If you are using this pump in a pressurizing system, you need a pressure switch, available
from
any pump or electric supply, or from your dealer. You may use the type used for AC
pumps.
determines at what
adjust your switch to your
pressure, the less en
ergy will be
Wire exactly as above. White is “neutral” and black is “hot”.
specifies that switches not disconnect the
switching only the positive. Using both
sets of contacts as shown (wired in series) will extinguish the arc (spark) that forms when the