Solar Force Install and User Manual

Installation & Service Manual
Innovative Solar Solutions, Inc
Main (866) 856-
9819
Observe minimum clearances for inspection and maintenance, as show.
surface, NOT on on rubber pads.
A
A.Intake:
Use 1 1/4" pipe OR LARGER (consult a pipe sizing chart to
drop). Treat this much like a drain line.
Avoid humps to eliminate air pockets. See text regarding suction
limitations! B. and C.
Outlet to Pressure Tank
pump outlet, then use 1 1/4" pipe and
check valve
elbows instead of 90°
elbows. Low friction piping will help to eliminate pulsation and noise. If pulsation
install a ST-
3000 Surge Tank, available from your Dankoff Solar Pump
1 Gal. size. See text.
D
D.
Use 1" or larger pipe in accordance with plumbing standards.
E.
(not shown) Pipe or hose from Pressure Relief Valve to safe drainage.
Manual in a clearly marked box nearby.
Installation & Service Manual
Innovative Solar Solutions, Inc
\ 1730 Camino Carlos Rey
, Unit 101/ Santa Fe, NM 87505
9819
\ Fax [phone] /
www.innovativesolar.com
2
Observe minimum clearances for inspection and maintenance, as show.
Bolt the pump directly to a strong, firm
surface, NOT on on rubber pads.
Expect traces of water and oil leakage at the rod packing.
Piping
Use 1 1/4" pipe OR LARGER (consult a pipe sizing chart to
determine a size for very low pressure
Avoid humps to eliminate air pockets. See text regarding suction
Outlet to Pressure Tank
: For a 3040 model pump, install a
1 1/4" X 1" reducer fitting at the
check valve
.
Keep it as short and straight as possible. Try to use 45°
elbows. Low friction piping will help to eliminate pulsation and noise. If pulsation
3000 Surge Tank, available from your Dankoff Solar Pump
s
dealer, or any expansion tank of around
Use 1" or larger pipe in accordance with plumbing standards.
(not shown) Pipe or hose from Pressure Relief Valve to safe drainage.
Store spare parts and Instruction
2010
, Unit 101/ Santa Fe, NM 87505
www.innovativesolar.com
Bolt the pump directly to a strong, firm
Expect traces of water and oil leakage at the rod packing.
determine a size for very low pressure
Avoid humps to eliminate air pockets. See text regarding suction
1 1/4" X 1" reducer fitting at the
Keep it as short and straight as possible. Try to use 45°
elbows. Low friction piping will help to eliminate pulsation and noise. If pulsation
persists,
dealer, or any expansion tank of around
Store spare parts and Instruction