Technical data

• Polling address - the HART address for the meter. By default the meter is 0 but
the address can range from 0 to 63.
4.
Configure the units that values will be read in over the HART interface.
• Volume units
• Flow rate time units
• Velocity
• Pressure
• Temperature
Configure meter corrections
The Field Setup Wizard Meter Corrections Page allows you to enter properties for:
• Temperature expansion correction
• Pressure expansion correction
Field Setup Wizard StartupFigure 4-14:
If an input is live, then the values corresponding to the minimum and maximum input (4
and 20 mA, respectively) are specified via data points (MinInputPressure,
MaxInputPressure, MinInputTemperature, MaxInputTemperature).
Daniel Liquid Ultrasonic Flow Meters calibration and configuration parameters
Operations 53