Technical data

2 Initial communication set up
Topics covered in this chapter:
• Set up meter communications
• Import a meter record
• Export a meter record
• Collect As Found logs and reports
• Customize Daniel MeterLink settings
• Set up Modbus communications
• Set up HART
®
communications
• Set up the meter in a DeltaV System
2.1 Set up meter communications
After the installation of your Daniel Ultrasonic Meter, install Daniel MeterLink
™
on your PC
or laptop as described in the Daniel MeterLink Software for Gas and Liquid Ultrasonic Flow
Meters Quick Start Manual (P/N 3-9000-763) for your operating system (Windows
®
2000,
Windows
®
Vista, Windows
®
7 or Windows
®
8), then configure the meter.
The installation CD is made available with the Daniel MeterLink Software for Gas and Liquid
Ultrasonic Flow Meters Quick Start Manual (P/N 3-9000-763) located inside the back cover.
The Daniel MeterLink installation program is available for download from the Daniel
Measurement and Control, Inc. website:
http://www.daniel.com/um2.htm
2.1.1 Daniel MeterLink
™
configuration utilities
Daniel MeterLink
™
provides the following utilities to configure the meter’s flow
measurement units, meter output parameters, communications settings, output tests,
waveforms, and logs and reports file management
• Field Setup Wizard
- Startup
- General
- Frequency/Digital Output Sources
- Frequency Outputs
- Meter Digital Outputs
- Current Outputs
- HART
®
Outputs
- Meter Corrections
Initial communication set up
Operations 3