Technical data

6. If the firmware upgrade fails again, contact Daniel Technical Support for assistance.
Contact information can be found in Daniel MeterLink under the Help pull down
menu by selecting Technical Support. Or, in the Customer service section in the
preface of this manual.
6.1.6 Warm start the meter
Selecting this command will prompt you Do you want to warm start the meter and disconnect from
it now? Click Yes to force the meter to restart.
A warm start is the same restart as when power is removed and reapplied to the meter. No
configuration or archive log history is lost. Some configuration changes require a restart of
the meter for the changes to take effect. Click No to close the dialog.
6.1.7 Communications analyzer
The Communications Analyzer is a Windows
®
application that displays “messages”
transmitted to and received from an addressable device, such as a Modbus slave, by
another Windows
®
application. The messages are display from the oldest (at the top of the
list) to the newest (at the bottom of the list). The Communications Analyzer date and time
stamps each message displayed. After 4096 messages have been displayed, the oldest
messages are cleared from the list as new messages are added.
The Address combo box filters new messages so that only those with the selected address
(1-32) are displayed. By default, all addresses are displayed. The address filter does not
affect messages already displayed, only new messages
Tools menu communications analyzerFigure 6-7:
1. Check Browse to disable automatic scrolling. This is useful if you want to look at a
certain message while new message are being added to the list.
2.
Click Copy to copy the messages to your clipboard so that they can be pasted into
another Windows application, e.g. Notepad.
Tools commands utility
110 Daniel 3810 Series Operations Manual