Technical data

Transducer chord parameters update
The Transducer Update page displays the Current Chord Parameters for the chord being
updated.
Transducer chord component changesFigure 6-6:
There are two groups of tables labeled Components Removed and Components Added. Only the
components previously selected will be editable. Enter in the lengths of all the
components removed and all the components added. Under New Chord Parameters, the new
calculated path length will be displayed.
If changing out Transducers, make sure to enter in the new Delay time and Delta time from
the report sheet provided with the transducer pair. Double check the values entered and
then click Write to Meter to write the New Chord Parameters to the meter. If this was the only
chord selected to change, the Transducer Swap-Out Wizard will close. If other chords
where selected to be changed, the Component Selection page will be displayed for the
next chord. The wizard will continue until all selected chords have changed.
Tools commands utility
Operations 107