Manual

38 | Page
STRIPPING FOR CLEANING
IMPORTANT: To prevent loss of small components during
stripping and cleaning, lay them out in an orderly fashion.
1. Read safety instructions in Section 3 and previous
CAUTIONS.
2. Press the rear take down pin in from the left hand side
of lower receiver and pull the pin out on the right hand
side of the receiver until it comes to a positive stop.
3. Pivot the lower receiver down and away from the
upper receiver.
4. If required for more convenience, completely separate
the upper receiver from the lower receiver by pressing
the front take down pin from the left hand side of the
lower receiver and pulling out the pin on the right hand
side of the receiver until it comes to a positive stop.
5. Pull charging handle to rear and remove the bolt carrier
group.
6. Remove the charging handle by pulling it backwards to
keyway and then down and out of the upper receiver.