Manual

30 | Page
READ SAFETY INSTURCTIONS (Section 3) – KEEP YOUR
FIREARM POINTING IN A SAFE DIRECTION AND DO NOT
TOUCH THE TRIGGER.
1. Remove empty magazine: depress magazine catch
which is located on the right side of the lower receiver,
and extract magazine from the magazine well.
2. Press in on bottom of thumb piece of bolt catch while
grasping and pulling back on the charging handle, to
cock the hammer and leave bolt and carrier latched
open to the rear.
THE BOLT CARRIER GROUP BEING LATCHED OPEN IS NOT A
SAFE CONDITION WHEN A LOADED MAGAZINE IS
INSTALLED.
3. Return charging handle fully forward until it locks and
remove finger from bolt catch.
4. Set selector lever (located on left of lower receiver) to
“SAFE”, this will lock the trigger.
5. With bullet points forward, insert the loaded magazine
into the magazine well and push it home until it stops
and is locked by the magazine catch. When the
magazine is inserted, pull down on the magazine to
ensure it is fully seated in the magazine well.
CAUTION
CAUTION: