Manual

25 | Page
If you have mounted a telescopic sight follow the zeroing
instructions provided with the sight. To zero your mechanical
sights here is the procedure to follow:
1. The front sight post and rear sight windage knob are
adjusted so you can hit your point of aim at 300 meters.
2. The small aperture must be in the up position.
3. During zeroing, only the front sight post and rear sight
windage knob are adjusted to move the point of bullet impact
on the target.
4. The rear sight consists of a rotating windage drum with a
spring loaded detent. To adjust the windage, depress the
detent, rotate the drum clockwise for adjustment to the left
and counter clockwise for adjustment to the right.
5. See “Tips on Aiming” (page 31) in the manual. Decide the
sight picture you want to use and stick with it while zeroing
your firearm.
6. Carefully aim at the target, take your time and fire 5
rounds.
7. If your shot group is not centered on the target in
elevation, measure the distance up or down from the center
of the target. Adjust the FRONT sight post by depressing the
sight plunger and turning the sight post the number of clicks
you calculate from the following chart:
Zeroing Sights