Manual

19 | Page
Fail Safe Firing Mechanism
In case of any failure of the firing mechanism, the top of the
hammer and the underside of the carrier are machined in
such a way that if the hammer was not held rearward by the
disconnect or trigger sear surface, then the hammer would
ride under the carrier and drop into engagement with the
back of the firing pin to stop or prevent firing.
Separation of Upper and Lower Receivers
In the event of functional problems, the lower receiver can be
separated from the upper receiver by pivoting it downwards
after pushing out the rear take down pin. This provides
access to the mechanism and separates the firing mechanism
from other components so that the cocked hammer can not
strike the firing pin.
NOTE: The Bolt Carrier Group must be in the full forward
position in order to separate the Upper Receiver from the
Lower Receiver.