Safety & Maintenance Instructions

FREEDOM. PASSION. PRECISION.
™
WARNING: READ AND UNDERSTAND ALL SAFETY INSTRUCTIONS
(SECTION 3).
1. Use only ammunition recommended in this instruction manual as suitable for
your rearm and application. The caliber your rearm is chambered in will be
engraved on the barrel near the chamber.
2. Examine the ammunition, particularly on and around the primer. Look
for dents, scratches, and other signs of damage. Do not load damaged
ammunition.
3. With the short end of the magazine facing forward, place a round between
the lips of the magazine with the bullet forward. Press the round down until it
is held by the magazine lips. Place next round on top of previous round and
repeat until desired number is loaded.
WARNING: TO MINIMIZE RISK OF UNINTENTIONAL DAMAGE, LOAD LIVE
AMMUNITION INTO YOUR MAGAZINE ONLY WHEN YOU ARE ABOUT TO SHOOT.
TO LOAD THE FIREARM:
IMPORTANT: READ SAFETY INSTRUCTIONS (SECTION 3) – KEEP YOUR
FIREARM POINTING IN A SAFE DIRECTION AND DO NOT TOUCH THE TRIGGER.
1. Remove empty magazine by depressing magazine catch, which is located
on the right side of the lower receiver (or on both sides of DD5), and extract
magazine from the magazine well.
2. Press on the bottom part of the bolt catch while grasping and pulling back on
the charging handle, leaving the bolt and carrier latched open to the rear.