User Manual

3. Use a clean cotton swab and a degreasing solution (acetone
or alcohol is recommended) to remove residue/debris from the
muzzle device threads.
4. Install beveled side of Daniel Defense alignment washer onto
host weapon in the direction toward the barrel shoulder. Beveled
side of spacer should face the barrel shoulder.
5. Using supplied shims, add/remove shims as needed to time
suppressor properly. If timed properly, the DD WAVE logo will
appear on the left side of the suppressor once installed.
6. Use torque wrench set at 20-30 ft. lbs. and combination/
crow’s-foot wrench (armorers tool) to tighten suppressor onto
host weapon. Do not torque suppressor beyond 30 ft. lbs. You
may need to remove suppressor and add/remove shims to orient
the timing of the suppressor correctly.
7. Once suppressor is timed properly and torqued to 20-30 ft.
lbs, remove suppressor. Apply a very small amount of supplied
Rocksett to barrel threads and re-torque suppressor onto host
weapon. (Ensure Rocksett does not drop on or into the bore)
Let Rocksett cure for 24 hours before using rearm.
11
7. QUICK-CLAMPING SUPPRESSOR
REMOVAL PROCEDURES
CAUTION!
DO NOT HANDLE SUPPRESSOR IMMEDIATELY AFTER
IT HAS BEEN USED IN LIVE-FIRE OPERATIONS. ALLOW
SUPPRESSOR TO COOL SUFFICIENTLY BEFORE HANDLING.
SURFACE OF THE SUPPRESSOR AND HOST WEAPON CAN
REACH TEMPERATURES CAPABLE OF INFLICTING SEVERE
BURNS IF HANDLED IMMEDIATELY AFTER LIVE-FIRE
OPERATIONS!
1. Unlock locking collar by rotating it counterclockwise until
it stops on the at faces of the locking tabs and the tabs are
aligned in the keyways on the locking collar.
2. Thread the suppressor counterclockwise off of the muzzle
device adapter.
8. DIRECT-THREAD SUPPRESSOR
ATTACHMENT PROCEDURES
1. Use a stiff bristle brush to remove debris from the barrel
threads. ( FIGURE 1)
2. Wipe remaining residue/debris from the barrel threads with a
clean cloth.
FIGURE 6