User Manual
7
5. REMOVAL OF FACTORY FLASH HIDER
AND CRUSH WASHER
FIGURE 3
1. Properly secure host weapon in a vise/xture. Use of a reaction
rod is recommended.
2. Insert combination wrench or crow’s-foot wrench (armorers
tool) onto wrench ats of the birdcage ash hider to loosen.
3. Remove ash hider from barrel of host weapon. (Black arrow,
FIGURE 3)
4. Remove and discard the factory-installed crush washer and
any other shims/washers present. (Gray arrow, FIGURE 3)
CAUTION: ONLY USE SPACERS AND SHIMS SUPPLIED BY
DANIEL DEFENSE! INSTALLING ANY COMPONENTS NOT
SUPPLIED BY DANIEL DEFENSE (CRUSH WASHER/SHIM)
COMPROMISES THE SUPPRESSOR ADAPTER ALIGNMENT
TO THE HOST WEAPON BORE. MISALIGNMENT OF THE
SUPPRESSOR ADAPTER MAY LEAD TO DAMAGE OR
CATASTROPHIC FAILURE OF THE SUPPRESSOR SYSTEM!
FIGURE 3
5.1 CLEANING PROCEDURES
1. Use a stiff bristle brush to remove debris from the barrel
threads. (Gray arrow FIGURE 4)
2. Wipe remaining residue/debris from the barrel threads with a
clean cloth.
3. Use a clean cotton swab and a degreasing solution (acetone
or alcohol is recommended) to remove residue/debris from the
muzzle device threads. (Black arrow, FIGURE 4)
5.2 ADAPTER TIMING
1. Install beveled side of Daniel Defense alignment washer onto
host weapon in the direction toward the barrel shoulder and as
indicated above (gray arrow, FIGURE 5). Beveled side of spacer
should face the barrel shoulder.
2. Using supplied shims, add/remove shims as needed to time
muzzle device where the threads end and begin at the 10pm
position. Orientation perspective is from behind the rie in the
shooting position. If timed properly, the DD WAVE logo will appear
on the left side of the suppressor once installed.
FIGURE 4