User's Manual

1. The DP G4 is NOT A TOY. Treat it with the same
respect and care you would a rearm.
2. Carelessness, Misuse, and failure to adhere
to the warning and guidelines printed in this
Owner’s Manual may result in property damage,
injury, or death. User assumes all risks
associated with use of the DP G4.
3. Always ensure that proper safety gear - eyes,
face, ear, and head protection - conforming to
ASTM standard F1776 (USA) or CE (Europe)
are worn at all times when paintballs are within
range.
4. Persons under the age of 18 must have adult
supervision at all times during use of the G4, or
any paintball ring device.
5. Observe all local and national laws regarding
rules and regulations.
6. The G4 should only be used on a permitted and
regulated paintball eld where safety rules and
guidelines are strictly enforced.
7. Only use compressed air or nitrogen. DO NOT
USE CO2!
8. Only use high quality, .68 caliber paintballs.
9. Never point your G4 at an unintended target.
10. Always treat your G4 as if it were loaded.
11. Keep your G4 turned OFF until ready to use.
12. Always measure the velocity of paintballs from
your G4 with a suitable chronograph device
before play.
13. Never look down the barrel or breech area of
the G4 without rst ensuring that the marker is
switched to the OFF position, with NO AIR in the
marker.
NOTE- SEE NOTE ON PAGE 3 FOR DIRECTIONS ON
REMOVING RESIDUAL AIR FROM A POWERED ‘OFF”
MARKER.
WARNING
IMPORTANT SAFETY INSTRUCTIONS AND GUIDELINES!
14. Never put any body parts or foreign objects into
the breech or feed tube.
15. Always use the supplied barrel cover when your
G4 is not in use at the eld. Doing so will help
secure the safety of yourself and those around
you.
16. Never allow pressurized gas to come into
contact with your body. Serious harm, injury, or
death may occur.
17. When not in use, always turn your G4 to the
OFF position.
18. Promptly remove any paintballs from your G4
when not in use.
19. Always remember to remove residual air from
your G4 before attempting maintenance or
service.
20. Always remember to remove residual air from
your G4 before storage or transportation.
NOTE- POWERING ‘ OFF’ THE MARKER WILL NOT
AUTOMATICALLY REMOVE RESIDUAL AIR. TO
SAFELY REMOVE RESIDUAL AIR, PLEASE DO THE
FOLLOWING:
A. Remove loader and paintballs from marker.
B. Turn Eye Sensors to the OFF position.
C. Point marker in a safe direction.
D. Fire marker until all residual gas is removed.
21. Always store your G4 in a safe place.
22. Do not discard the Owner’s Manual. In the event
of transfer or resale, this guide must accompany
the marker.
23. When in doubt, ALWAYS seek expert advice
by contacting a reputable airsmith familiar with
paintball markers, or by contacting
DP Engineering’s Customer Service Staff.
WARNING
IMPORTANT SAFETY INSTRUCTIONS AND GUIDELINES!
W W W . D A N G E R O U S P O W E R . C O M
02 03