User's Manual

RAPS™ FLIP LEVER ASA

REMOVAL AND MAINTENANCE (CONTINUED)

5. Locate front and back screws within grip frame as illustrated, and unscrew with (3/32”) allen key wrench.

(SEE PIC E . F)

6. Slide RAPS

ASA forward on rail to remove from frame. (SEE PIC G)

7. Locate hex screw on RAPS

ASA casing.

8. Using (5/64”) allen key wrench, loosen and remove screw by turning it counterclockwise. (SEE PIC H)

9. Remove RAPS

lever and piston from RAPS

casing as shown.

10. Check spring for proper tension. Replace if worn or damaged.

G HE F

RAPS™ FLIP LEVER ASA

REMOVAL AND MAINTENANCE (CONTINUED)

WARNING

REMEMBER TO DE-GAS THE G4 BEFORE SERVICING THE RAPS

ASA. FOLLOW INSTRUCTIONS

PREVIOUSLY OUTLINED ON PAGE 27 TO SAFELY AND PROPERLY REMOVE EXCESS AIR FROM THE

MARKER.

11. Use a lightly dampened cloth and/or cotton swab to remove debris or grime from all RAPS

ASA

compenents, including the piston, spring, lever, and casing. (SEE PIC I)

12. Clean and inspect o-ring located on the base of the piston. Replace o-ring if it appears worn, cracked, or

damaged. Using a cotton swab, apply a small amount of DP-40 lubricant on the o-ring. (SEE PIC J)

13. Make sure the spring is properly seated on the piston, then reassemble the RAPS

ASA in the reverse order

of assembly. (SEE PIC K)

I KJ

W W W . D A N G E R O U S P O W E R . C O M

44 45