User's Manual
1. Locate the two trigger adjustment screws. Use (5/64”) allen key wrench to loosen and remove both screws by
turning them counterclockwise. Be careful not to misplace the screws. (SEE PIC A . B)
2. Locate trigger removal screw. Use (3/32”) allen key wrench to loosen and remove screw by turning it
counterclockwise. Carefully pull out screw. Note that the latter part of the screw is a bolt, which the trigger
hinges upon. (SEE PIC C)
3. Remove trigger assembly by lifting it up and out of G4 trigger frame. (SEE PIC D)
REMOVING TRIGGER FROM FRAME
B C DA
RAPS™ FLIP LEVER ASA
REMOVAL AND MAINTENANCE
The RAPS
TM
ASA was designed to be virtually maintenance free. However, it may be necessary to occasionally
clean and inspect for debris or damage, as either may cause malfunction or leaking of air.
1. Remove macro-line from RAPS
TM
ASA. (SEE PIC A)
2. Remove buttery grip panels from trigger frame. (SEE PIC B)
3. Disconnect solenoid wiring harness and eye wiring harness from circuit board. (SEE PIC C)
4. Locate the three screws securing circuit board to trigger frame and unscrew using a crosshead (Phillips)
screwdriver. Carefully remove the circuit board from the trigger frame. (SEE PIC D)
B C DA
W W W . D A N G E R O U S P O W E R . C O M
42 43