User's Manual

SEPARATING G4 BODY FROM TRIGGER FRAME

1. Remove macro-line from RAPS

ASA. (SEE PIC A)

2. Carefully remove the 2 hexagonal screws (3/32”) holding the left panel in place. (SEE PIC B)

3. Gently secure the base of the connectors and pull up to remove the plugs. DO SO ONE AT A TIME. It may be

helpful to use needle nose pliers. Note the location and direction of the connectors on the circuit boar for

reassembly. (SEE PIC C . D)

A CB

F GE

SEPARATING G4 BODY FROM TRIGGER FRAME

(CONTINUED)

4. Locate screw #1 underneath G4 body between OPR and Trigger Guard and screw #2 behind the trigger

frame. Using (3/32”) allen key wrench, loosen Connector Screw by turning it counterclockwise.

(SEE PIC E . F)

5. Separate the G4 body from the trigger frame. (SEE PIC G)

W W W . D A N G E R O U S P O W E R . C O M

38 39