User's Manual

1. Unscrew front of barrel from G4 body.
2. Use supplied allen key wrench (1/4”) on the back of marker and unscrew back cap. (SEE PIC A)
3. Remove Dump Valve Plug from marker body. (SEE PIC B)
4. Remove Dump Valve Bolt from marker body. It may be necessary to use your nger to pull it or push it out, as
illustrated. (SEE PIC C)
5. Wipe off all visible debris and grime from the Dump Valve Bolt, Dump Valve Plug and internal of G4 body with
a soft dampened cotton cloth and cotton swab.
DISASSEMBLY AND MAINTENANCE OF DUMP
VALVE BOLT AND DUMP VALVE PLUG
B CA
DISASSEMBLY AND MAINTENANCE OF DUMP
VALVE BOLT AND DUMP VALVE PLUG (CONTINUED)
WARNING
NEVER USE FORCE DURING DISASSEMBLY OR REASSEMBLY. ALWAYS SEEK ASSISTANCE FROM A
QUALIFIED AIRSMITH OR CONTACT DP ENGINEERING CUSTOMER SERVICE IF YOU ARE UNCERTAIN
OF ANY INSTRUCTIONS DESCRIBED IN THIS MANUAL.
NOTE
THE ABOVE STEPS ARE ALL THAT ARE REQUIRED FOR NORMAL BOLT MAINTENANCE. PROCEED
FURTHER TO ACCESS SOLENOID AND TRIGGER.
4. Lightly apply DP-40 lubricant to the tip of a cotton swab.
5. Apply lubricant directly onto the Dump Valve Bolt. (SEE PIC D)
6. Apply lubricant to the two o-rings located on the Dump Valve Plug. (SEE PIC E . F)
ED F
W W W . D A N G E R O U S P O W E R . C O M
36 37