User's Manual

4. Carefully lift eye wires and pull out the eye sensors from the socket. Be careful not to lose the spring and the
ball detent. (SEE PIC D)
5. With a cotton swab, gently wipe the back and front side of the eye sensor and the eye socket to remove any
debris or residue. (SEE PIC E)
6. Replace eye sensors back to original position. Be sure the eyes are aligned correctly and facing the direction
of the breech.
7. Replace eye cover plate in original position and gently tighten eye cover screws clockwise. DO NOT OVER-
TIGHTEN! (SEE PIC F)
8. Repeat the same procedure on the other side.
CLEANING THE EYE-SENSOR BREAK BEAM SYSTEM
(CONTINUED)
HELPFUL HINT
DO NOT PULL ON THE EYE WIRES. USE A SMALL PICK OR SCREW DRIVER TO GENTLY LIFT THE
WIRES UP. THIS WILL LIFT THE EYE SENSORS OUT OF THE EYE SOCKET.
ED F
The ball detents and spring should be inspected during the cleaning of the eye sensors. Replace these parts
should you notice any damage, no matter how slight.
1. Locate the eye cover plates on either side of your G4 body.
2. Using provided allen key wrench (5/64”), carefully remove the eye cover screw on one side by inserting ball
point tip and turning wrench handle counterclockwise. (SEE PIC A)
3. Lift eye cover plate, exposing eye wires, spring, and ball detent. (SEE PIC B)
4. Remove spring by carefully lifting it up by hand or with the aid of small tweezers. (SEE PIC C)
CLEANING THE BALL DETENTS
B CA
W W W . D A N G E R O U S P O W E R . C O M
30 31