User's Manual

• Setting Options as below:
Functionality
Mode
LED
Factory
Default
Min/Max
Rate Of Fire
Red 13 5/35
Firing Mode
Green 1 1/4
Ramp Point
Yellow 3 1/10
Trigger Debounce
Red Flash 10 1/20
Solenoid Dwell
Green Flash 12 5/25
ABS Dwell
Yellow Flash 4 1/4
PROGRAMMING YOUR G4 (CONTINUED)
▌ SOLENOID DWELL
This value controls the allotted time (in milliseconds) the solenoid is open. If too low, the marker will not cycle. If
the value is too high, the solenoid with remain open too long therefore wasting decreasing battery and air efciency.
▌ ABS DWELL
Adds an additional 1-3 milliseconds of dwell time to the programmed solenoid dwell setpoint on the rst shot of any
string of shots after a xed 20 seconds of shooting inactivity. A value of 4 disables the ABS Dwell feature.
Mode Description
Semi
Fire 1 shot per trigger pull.
PSP3
Three semi shots then transitions to 3 Rounds Burst. Returns to semi mode after 1 sec-
ond of no activity.
NXL
Semi for the rst 3 shots, then full automatic on the 4
th
pull and hold. Rests to semi after 1
second of no activity.
Millennium
When triggering pull speed up to 7.5 BPS ramping will turn on at the 6
th
trigger pull, when
trigger pull speed lower than 7.5 BPS then the re mode will be back to semi re mode.
▌ FIRING MODE
PROGRAMMING YOUR G4 (CONTINUED)
3. CONFIGURATION MODE
W W W . D A N G E R O U S P O W E R . C O M
24 25