User's Manual
VELOCITY ADJUSTMENT
WARNING
DP ENGINEERING RECOMMENDS THAT THE VELOCITY NEVER EXCEED 300 FPS. FAILURE TO
FOLLOW REGULATIONS REGARDING MAXIMUM ALLOWABLE VELOCITY, CALCULATED IN FEET PER
SECOND (FPS), MAY RESULT IN DAMAGE OF PAINTBALL MARKER, SERIOUS INJURY OR DEATH. BE
RESPONSIBLE AND ALWAYS USE A CHRONOGRAPH TO DETERMINE ACCURATE VELOCITY BEFORE
PLAY.
• Locate the (1/8”) allen key wrench included with your G4.
• Adjust screw located at the side of the Operating Pressure Regulator (OPR) to increase or decrease velocity.
• Turn screw counterclockwise to increase velocity.
• Turn screw clockwise to decrease velocity.
• There are four adjustment screws (marked A, B, C and D) to adjust the trigger on the G4.
• Screw A (5/64”) adjusts the amount of trigger travel prior to the marker ring. Turning this screw clockwise will
reduce the amount of trigger travel. Turning this screw counterclockwise will increase the amount of trigger
travel. (SEE PIC A)
• Screw B (5/64”) sets the amount of trigger travel after the marker has been red. Turning the screw clockwise
will reduce the amount of trigger travel. Turning the screw counterclockwise will increase the amount of trigger
travel. (SEE PIC B)
TRIGGER ADJUSTMENT
+
-
A B
W W W . D A N G E R O U S P O W E R . C O M
18 19