User's Manual

Pull back the collet section of the macro-line elbow located on your RAPS
TM
ASA. (SEE PIC A)
Keeping the collet back, insert macro-line hose rmly into the tting and release the collet. Be sure that the
hose is seated all the way into the end of elbow tting. (SEE PIC B . C)
Repeat the same process on the macro-line elbow located on your OPR to connect the RAPS
TM
ASA.
CONNECTING MACRO-LINE TO HIGH PRESSURE
REGULATOR AND QUICK RELEASE FLIP LEVER ASA
(RAPS
TM
)
WARNING
IMPROPER FITMENT WILL CAUSE PHYSICAL INJURY. ALWAYS INSPECT MACRO-LINE HOSE SEATED
ALL THE WAY INTO THE END OF THE ELBOW.
Swing ip lever to the ‘release’ position. (SEE PIC A)
Attach air tank by carefully screwing it into the threaded portion of the RAPS
TM
ASA. Make sure tank tment is
tight and all the way in. (SEE PIC B)
Return ip lever of the RAPS
TM
ASA to the ‘close’ position. (SEE PIC C)
A brief sound of air entering the system is normal. The G4 is now pressurized. (SEE PIC D)
ATTACHING AIR TANK TO RAPS
TM
FLIP LEVER ASA
WARNING
NITROGEN OR COMPRESSED AIR TANKS ONLY! NEVER USE CO2.
A B C A B C D
W W W . D A N G E R O U S P O W E R . C O M
16 17