User's Manual

ATTACHING A PAINTBALL LOADER

• Loosen thumbscrew counterclockwise by hand.

• Release clamp on feedneck.

• Insert feed tube of loader unit.

• Close clamp securely. Loader should fit snug within feedneck.

• If loader is too loose, remove and adjust thumbscrew.

• Pull back the collect section of the macro-line elbow located on your RAPS

ASA.

• Keeping the collet back, insert macro-line hose rmly into the tting and release the collet. Be sure that the

hose is seated all the way to the end of elbow tting.

• Repeat the same process on the macro-line elbow located on your HPR to connect the RAPS

ASA.

CONNECTING MACRO-LINE TO HIGH PRESSURE

REGULATOR AND QUICK RELEASE FLIP LEVER ASA

(RAPS

)

WARNING

BE SURE TO REGULARLY INSPECT THE CONDITION OF YOUR MACRO-LINE HOSE TO ENSURE

PROPER FITMENT. ALWAYS CHECK TO MAKE SURE THE MACRO-LINE HOSE IS SEATED ALL THE WAY

TO THE END OF THE ELBOW.

WARNING

TAKE CARE NOT TO USE EXCESSIVE FORCE - DOING SO MAY CAUSE DAMAGE TO LOADER OR THE

G3 Spec-R!

W W W . D A N G E R O U S P O W E R . C O M

14 15