User's Manual

RAPS™ FLIP LEVER ASA
REMOVAL AND MAINTENANCE (CONTINUED)
5. Locate front and back screws within grip frame as illustrated, and unscrew with (3/32”) allen key wrench.
(SEE PIC E . F)
6. Slide RAPS
TM
ASA forward on rail to remove from frame. (SEE PIC G)
7. Locate hex screw on RAPS
TM
ASA casing.
8. Using (5/64”) allen key wrench, loosen and remove screw by turning it counterclockwise. (SEE PIC H)
9. Remove RAPS
TM
lever and piston from RAPS
TM
casing as shown.
10. Check spring for proper tension. Replace if worn or damaged.
G HE F
RAPS™ FLIP LEVER ASA
REMOVAL AND MAINTENANCE (CONTINUED)
WARNING
REMEMBER TO DE-GAS THE G3 SPEC-R BEFORE SERVICING THE RAPS
TM
ASA. FOLLOW
INSTRUCTIONS PREVIOUSLY OUTLINED ON PAGE 41 TO SAFELY AND PROPERLY REMOVE EXCESS
AIR FROM THE MARKER.
11. Use a lightly dampened cloth and/or cotton swab to remove debris or grime from all RAPS
TM
ASA
compenents, including the piston, spring, lever, and casing. (SEE PIC I)
12. Clean and inspect o-ring located on the base of the piston. Replace o-ring if it appears worn, cracked, or
damaged. Using a cotton swab, apply a small amount of DP-40 lubricant on the o-ring. (SEE PIC J)
13. Make sure the spring is properly seated on the piston, then reassemble the RAPS
TM
ASA in the reverse order
of assembly. (SEE PIC K)
I KJ
W W W . D A N G E R O U S P O W E R . C O M
44 45