User's Manual

• There are three (3) adjustment screws (marked A, B and C) to adjust the trigger on the G3 Spec-R.
• Screw A (5/64”) adjusts the amount of trigger travel prior to the marker ring. Turning this screw clockwise will
reduce the amount of trigger travel. Turning this screw counterclockwise will increase the amount of trigger
travel.
• Screw B (5/64”) sets the amount of trigger travel after the marker has been red. Turning the screw clockwise
will reduce the amount of trigger travel. Turning the screw counterclockwise will increase the amount of trigger
travel.
• Screw C (3/32”) adjusts the strength of the trigger’s return to rest by either reducing or increasing the
magnetic pull. Turning this screw counterclockwise will decrease the strength. Turning this screw clockwise
will increase the strength. Do not turn the screw too far - doing so may weaken the magnetic pull and prevent
the trigger from being able to fully return to rest.
TRIGGER ADJUSTMENT
B CA
PROGRAMING MODE
OPERATION
Programming mode cycles
through setpoints and enters
setpoint values via pulls.
LED
POWER ON
Green light indicate battery level
ok, Red light indicate battery
level low.
TRIGGER
Fires the marker.
FIRING MODE OPERATION
Firing mode Invokes program-
ming mode at power up.
POWER BUTTON
POWER ON
Press and hold until illuminates.
Release and marker is ready to
re.
POWER OFF
Press and hold 2 seconds until
board turns off. Release and
marker is off.
EYE CONTROL
Tap to toggle eye sensor on/off.
BOARD
NOTE
BE CAREFUL NOT TO TURN THE SCREW TOO FAR IN EITHER DIRECTION, AS DOING SO MAY PUSH
THE TRIGGER PAST THE FIRING POINT AND CAUSE OPERATIONAL FAILURE.
W W W . D A N G E R O U S P O W E R . C O M
18 19