User's Manual
W W W . D A N G E R O U S P O W E R . C O M
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Not activated
Hold down operating button for more than 4
seconds
Low battery power Replace with fresh battery
Battery is connected incorrectly to
the PC board
Check to see if the battery cable is connected
correctly to the terminal
Low battery power Replace with fresh battery
Low air pressure Rell the air system
OPR pressure is too low Adjust OPR pressure without paintball present
PROBLEM POSSIBLE CAUSE SOLUTION
Poppet valve no seal Clean air chamber module
Barrel size does not match paintball’s
The stock barrel size is 0.690,change if
necessary
Ball detent is worn Change ball detent
Sensor system is not on Switch it to ON
Low battery power Replace with fresh battery
62 63
PROBLEM POSSIBLE CAUSE SOLUTION
No paintball present Turn on the loader
Sensor system is unclean Remove and clean sensor eye
Broken paintball inside Refer to bolt maintenance
Ball detent is damaged Change ball detent
Air pressure is too low Adjust the operating pressure to 150 to 200 psi
Dwell time is too short See page 33 “ Solenoid Dwell adjust ”
Low battery power Change battery
Hammer o-ring is worn Change o-ring
Hammer o-ring lubricant is exhaust Lubricate the o-ring with Dow-55 lubricant