User's Manual

W W W . D A N G E R O U S P O W E R . C O M

58 59

RAPS™ FLIP LEVER ASA

REMOVAL AND MAINTENANCE

The RAPS

ASA was designed to be virtually maintenance

free. However, it may be necessary to occasionally clean and

inspect for debris or damage, as either may cause malfunction

or leaking of air.

1. Remove macro-line from RAPS

ASA. 

2. Remove buttery grip panels from trigger frame.

3. Disconnect solenoid wiring harness and eye wiring

harness from circuit board. 

4. Locate the three screws securing circuit board to trigger

frame and unscrew using a crosshead (Phillips)

screwdriver. Carefully remove the circuit board from the

trigger frame. 

RAPS™ FLIP LEVER ASA

REMOVAL AND MAINTENANCE (CONTINUED)

5. Locate front and back screws within grip frame as

illustrated, and unscrew with (3/32”) allen key wrench.



6. Slide RAPS

ASA forward on rail to remove from frame.



7. Locate hex screw on RAPS

ASA casing.

8. Using (5/64”) allen key wrench, loosen and remove screw

by turning it counterclockwise. 

9. Remove RAPS

lever and piston from RAPS

casing as

shown.

10. Check spring for proper tension. Replace if worn or

damaged.