User's Manual

W W W . D A N G E R O U S P O W E R . C O M

54 55

SEPARATING FX BODY FROM TRIGGER FRAME

1. Carefully remove the 2 hexagonal screws (3/32”) holding

the left panel in place. 

2. Gently secure the base of the connectors and pull up to

remove the plugs. DO SO ONE AT A TIME. It may be

helpful to use needle nose pliers. Note the location and

direction of the connectors on the circuit boar for

reassembly. 

3. Locate screw #1 underneath FX body between OPR and

Trigger Guard and screw #2 behind the trigger frame.

Using (3/32”) allen key wrench, loosen Connector Screw

by turning it counterclockwise. 

4. Separate the FX body from the trigger frame.



SOLENOID MAINTENANCE

The FX solenoid is a delicate electronic component that

requires minimal maintenance or service. DP Engineering does

not recommend frequent cleaning of this part, or its internals.

The following instructions are provided for reference and for

expert airsmiths only.

1. Follow Page 54 continued operation next step.

2. Using (5/64”) allen wrench key, locate and remove both

screws securing the solenoid to the marker body.



3. Once both screws are removed, gently lift and remove

the solenoid. 

4. Place solenoid on a at surface, with the wiring harness

side facing down and solenoid disassembly screw facing

up.

5. Secure base of solenoid casing with an adjustable

wrench (not provided). Using a slotted (athead)

screwdriver, remove screw carefully by turning it

counterclockwise. Be extremely careful not to strip the

screw. 